Power Steering Pump Gasket — Pump-to-Housing Oil Seal SKU: QT1833974

This power steering pump gasket seals the joint between the pump and housing to keep hydraulic fluid contained and pressure stable. It’s a practical fix for seepage that causes spots under the tractor and slippery residue around the pump.

Made for everyday service, it handles temperature swings and vibration so clamp load stays consistent after warm-up. Use it when resealing the pump during maintenance or after replacing bearings or shafts.

• Purpose-built gasket for pump-to-housing sealing in hydraulic systems
• Helps prevent fluid leaks that reduce assist and create mess
• Compressible design supports torque retention under vibration
• Suitable for routine service, rebuilds, and post-repair reassembly

Installation Tip: Clean both mating surfaces thoroughly, remove old gasket material, and check the cover for warping; install the gasket dry unless your service guide specifies a sealant, then torque fasteners in a cross pattern and recheck after initial operation.

A straightforward, dependable seal that helps keep steering assist consistent and your equipment working smoothly.