Rocker Cover Gasket — Valve Cover-to-Head Oil Seal SKU: QT36811115

This rocker cover gasket seals the joint between the valve (rocker) cover and the cylinder head to keep engine oil contained and off the outside of the engine. Use it to address seepage that causes burnt-oil smell, grime buildup, and messy cleanups.

Built for everyday use, it stands up to heat cycles and vibration so clamp load stays consistent after warm-up. A practical choice anytime you service valvetrain components or reseal a weeping cover.

• Purpose-built gasket for the valve/rocker cover-to-head interface
• Helps prevent oil leaks that attract dust and dirt
• Supports stable torque retention through repeated temperature swings
• Suitable for routine maintenance, refreshes, and post-service reassembly

Installation Tip: Clean both surfaces thoroughly, remove old gasket material, and inspect the cover for warping; install evenly and torque fasteners in sequence, then recheck after the first heat cycle.

A straightforward, reliable seal that helps keep the engine clean and your equipment working smoothly.