Rocker Cover Gasket — Valve Cover-to-Head Oil Leak Seal SKU: QT36811122

This rocker cover gasket seals the joint between the valve (rocker) cover and the cylinder head to keep engine oil inside the cover and off the block. It’s a practical way to fix weeping that causes burnt-oil smell, grime buildup, and messy cleanups.

Built for everyday service, it tolerates heat cycles and vibration so clamp load stays consistent after warm-up. Use it anytime you reseal a cover during tune-ups or after valvetrain work.

• Purpose-built gasket for the valve/rocker cover-to-head interface
• Helps stop oil seepage that attracts dust and dirt
• Supports reliable torque retention through temperature swings
• Good choice for routine maintenance and post-service reassembly

Installation Tip: Clean both surfaces thoroughly, remove old gasket material, and check the cover for warping; install evenly and torque fasteners in sequence, then recheck after the first heat cycle.

A straightforward, dependable seal that helps keep the engine clean and your equipment working smoothly.