Oil Pan (Sump) Gasket Set — Reseal Kit for Pan Rail & End Seals SKU: QT63036

This oil pan (sump) gasket set restores a leak-tight seal around the pan so engine oil stays inside the crankcase and off the outside of the block. Use it to stop drips that attract dust, make a mess on the chassis, and waste oil.

Built for day-in, day-out service, the components handle heat cycles and vibration to help the joint hold torque after warm-up. It’s a practical choice when buttoning up after bottom-end work or during a mid-season refresh.

• Configured to reseal the oil pan (sump) perimeter and related joints
• Helps control seepage at corners and timing cover/block junctions
• Supports long-term clamp load retention through temperature swings
• Suitable for routine maintenance, refreshes, and post-repair reassembly

Installation Tip: Clean mating surfaces thoroughly, check the oil pan (sump) rail for straightness, use small dabs of RTV at corner junctions if specified by your service guide, and torque fasteners in a cross pattern; recheck after the first heat cycle.

A straightforward, dependable reseal kit that keeps the engine cleaner and your equipment working smoothly.