Pivot Housing Gasket — 0.006 in (0.15 mm) Thick, fits 12 mm studs SKU: QT7963

This pivot housing gasket seals the joint at the front axle pivot so gear oil stays in and dust stays out. It’s a practical fix to stop seepage that leaves spots and attracts grime around the axle center.

Built for daily service, it holds torque through heat cycles and vibration so the joint stays sealed after warm-up. Use it during routine maintenance or anytime you open the pivot housing for inspection.

• Thickness: 0.006 in (0.15 mm)
• Stud compatibility: 0.47 in (12 mm)
• Helps control leaks at the axle pivot housing interface
• Compressible design supports clamp load under vibration

Installation Tip: Clean both mating faces, remove old gasket material, check flange flatness, and torque fasteners in sequence; recheck after the first heat cycle.

A straightforward, dependable gasket that helps keep the front axle cleaner and your equipment working smoothly.